Generic Iduino L298N Motor Driver Controller Board Dual H-Bridge Dc Stepper Compatible Arduino Uno Mega R3 Mega2560 Duemilanove Nano  (Multicolor)

IDUINO L298N Motor Driver Controller Board Dual H-Bridge DC Stepper Compatible Arduino UNO MEGA R3 Mega2560 Duemilanove Nano Robot The driver chip: double H bridge driver L298N chip | The driving part of the terminal power supply scope VMS: + 5 v ~ + 35 v | The driving part of the peak current Io: 2 a/bridge | The logical part Vss terminal power supply range: 4.5 to 5.5 V | Working current range: 0 ~ 36 ma This L298N driver module, use the ST's L298N chip, can direct drive two road 3-30 v dc motor, and provides a 5 v output interface, can give a 5 v power supply circuit system, support 3.3 VMCU control, easy to control dc motor speed and direction, and can also control two phase stepper motor, is a smart car essential. Product parameters: 1. The driver chip: double H bridge driver L298N chip 2. The driving part of the terminal power supply scope VMS: + 5 v ~ + 35 v 3. The driving part of the peak current Io: 2 a/bridge 4. The logical part Vss terminal power supply range: 4.5 to 5.5 V 5. The logical part of the working current range: 0 ~ 36 ma. 6. Control signal input voltage range: 4.5 5.5 V low level high level 0 V 7. Maximum power consumption: 20 w 8. Storage temperature: 25 ? ~ + 130 ? 9. Drive plate size: 55 mm * 60 mm * 30 mm 10. Driver board weight: 33 g 11. Other functions: control the direction of light, the power indicator, current detection, logical part within plate for electrical interfaces.