JUNIOR JOE Portable Baby Travel Bed Folding Newborn Baby Crib Remote Control Baby Cradle Infant Bed Multi-function Sleepy with Mosquito Net Bassinet  (Grey)

BRACKET ASSEMBLY :- 1. Take Out The Bed Wall , remove The Nylon Webbing Buckle On Both Sides Of The Bed Wall, And Put Them Into The Bottom Pipe Respectively 2. Squeeze The Spring Of The Bottom Tube To Fit The Bottom Tube Into The Hole Of Another Bottom Tube to Form a Whole 3.Expand The Main Function Head ( WITH BUTTONS ) And The Sub Head, The Main Head Is On The Right, And The Sub Head Is On The Left. Snap The Main And Auxiliary Head Support Tubes Into The Corresponding Holes Of The Bottom Tube. ( As The Picture Shows ) REMOTE CONTROL :- 1. CONNECT THE POWER SUPPLY :- Connect The Power Supply The Power Cord Hole Is Directly Below The Head Of The Main Unit. It Is Necessary To Insert The DC Round Head Interface, Connect The Power Supply, And Use It After The Gear Indicator Light Is On. 2. USB MUSIC PLAY :- The USB Interface Is Located At The Lower Back Of The Host Head. When You Need To Play External Music, Just Insert The USB Disk Into The USB Interface To Play The Music. HOW TO USE MOSQUITO NET :- 1. Spread The Mosquito Net Over One Side Of The Bed Enclosure Bracket And Stretch Along The Edge Of The Bed Enclosure Until The Entire Bed Cover Is Wrapped. When Stretching , Pay Attention To Whether The Two Sided Of The Rubber Band Are Evenly Symmetrical. FIXED BED ENCLOSURE :- 1. After Mounting The Bed Enclosure To The Corresponding Hole Of The Swing Arm Support Tube, Use The Screws And Nuts In The Accessory Kit To Tighten The Bed Enclosure.