MAKER AND HACKER Ethernet Shield Wiznet W5100 for Arduino with Memory card slot Micro Controller Board Electronic Hobby Kit

The Arduino Ethernet Shield allows you to easily connect your Arduino to the internet. This shield enables your Arduino to send and receive data from anywhere in the world with an internet connection. You can use it to do fun stuff like control robots remotely from a website, or ring a bell every time you get a new twitter message. This shield opens up endless amounts of possibility by allowing you to connect your project to the internet in no-time flat. Features: · Operating voltage 5V (supplied from the Arduino Board) · Ethernet Controller: W5100 with internal 16K buffer · Connection speed: 10/100Mb · Connection with Arduino on SPI port · The Shield contains a number of informational LEDs · PWR: indicates that the board and shield are powered · LINK: indicates the presence of a network link and flashes when the shield transmits or receives data · FULLD: indicates that the network connection is full duplex · 100M: indicates the presence of a 100 Mb/s network connection (as opposed to 10 Mb/s) · RX: flashes when the shield receives data · TX: flashes when the shield sends data · TX: flashes when the shield sends data · COLL: flashes when network collisions are detected Other details · Datasheet · Arduino Ethernet Shield Page · Manual · Library Package Includes: 1 Piece new W5100 Ethernet Shield for Arduino Uno And Mega Module can be used with Arduino, Mbed, ARM or any other MCU