PAVITYAKSH BOOSTER CABLE 500AMP Clamp with Alligator Wire 500Amp 13 ft Battery Jumper Cable  (Pack of 1)

The material of the clip head is copper and has excellent conductivity [The connection procedure is as follows] (1) First, clamp the red wire of the start line above the red battery anode of the "rescued car". (2) Then clamp the red wire on the other end over the red battery anode of the "rescue car". (3) Clamp the black wire on the black negative battery of the "rescued car". (4) Then clamp the black wire on the black negative battery of the "rescue car". (5) Start the engine of the "rescue car" before starting the engine of the "rescue car". If it is found that the rescued vehicle still cannot start, please check whether the metal contact part is in bad contact. After starting the engine, you must still remove the starting ground wire in order, otherwise, it may cause a short circuit. [The procedure for removing the line is as follows] (1) First, remove the black wire from the "rescued car". (2) Remove the black wire from the "rescue vehicle" again. (3) Then remove the red wire from the "rescue vehicle". (4) Finally, remove the red wire from the "rescued car". NOTE: It is recommended to use a 500A / 700A ground wire for a displacement below 2.0