REES52 High Voltage Transformer Generator for DC 3V-6V to 400kV 400000V Boost Step-Up Power Module Electronic Components Electronic Hobby Kit

REES52 400KV Boost Step Up Power Module with 2 Line Output Input High-voltage Transformer Generator uses the principle Tesla coil is made of high-voltage pulse output voltage; This module is a small production with high-pressure science inverter transformer / booster finished module, the input terminal DC3V-7.2V voltage can get 200,000 volts for DC high voltage ( about 1-2cm arc ) at the output can be used as high school science experiments, electronic equipment, negative ion generator, high voltage source to use when making small science. About Power: 3.7V Li-ion battery can be used single or two series, such as 18650, idle cell phone batteries ( to remove the for protection board, the proposed capacity of 2000mAh or more ) or NiCd / NiMH battery pack, 4V or 6V Lead Acid batteries; Input power cable length: about 10mm (red is positive); Dimensions 24 x 63mm Please Note: Avoid high-pressure high-voltage module load electricity use. Must adjust the high voltage side suitable distance (before electricity, battery voltage and capacity is proportional to the distance from high-voltage arcing used when testing the arc distance from short to long experiment, prohibited from beyond the arc when powered up, the energy can not be released due to high pressure, easily damage the module). Due to power, the internal heat is not easy, every power-on time should be controlled within a minute. Two sections of small capacity lithium series of 7.2V, measured arc voltage has dropped to about 4V state, the capacity of the smaller voltage pulled lower. It is recommended to use more than one lithium battery 2000mA, 4000mA best conditions with more battery. Uses: Widely used for 105 high-voltage generator, high voltage ignition, teaching experiments. Package: 1 x 3-6V to 400kV Boost Step-up Power Module.