SARRU CC71 Air Cooler Remote Controller for Fan300W Pump & Swing with Sleep Mode and Programmable Electronic Timer Switch  (Black)

Sarru CC71 Desert Air Cooler Remote Controller provides you 10 steps (0=off,1,2,3,4,5,6,7,8 and 9=full speed) different comfortable fan speeds regulation. You can also set water pump motor at different 6 pre-programmed duty cycles ON-OFF settings to control the humidity level. At 0= pump is continuous OFF, at setting 1=min ON and 4 min OFF..., at 2=2min ON and 3 min OFF..., at 3=3min ON and 2 min OFF..., at 4=4 min ON and 1 min OFF... & at5= continuous ON. You can also turn ON or OFF swing fan with remote swing button. This controller also provides you Sleep mode and ON/OFF timer. When sleep mode is turned ON the fan speed will be automatically reduce by 1 step in every 1 hour till it reaches to speed number 2. This function is very useful in night time. The timer can be set when system is in either ON or OFF condition. The timer value can be set in steps of 1 hour from 1 hour to 9 hours (1,2,3,4,5,6,7,8 and 9 ). Once set timer is over, cooler fan + water pump motor + swing fan motor will automatically turn ON to OFF or OFF to reset ON. Controller keeps fan, pump and swing setting stored in it’s memory even power goes away. System can be fully controlled by remote buttons as well as fan, pump and system ON/OFF can also by controlled by controller panel three switches. Remote range is more than 30 feet in line of sigh. Fan circuit load capacity max. 300 watt, water pump max. 100 and swing fan max. 100watt at 230V, 50Hz. All functions like fan speed, pump settings, timer value , sleep mode value etc. are shown on display. Do not install this controller along with old wiring. Make sure to remove the old wiring of fan, water pump and swing motor form the circuit. Connect wires of fan, water pump and swing motor directly to our controller and there should be no other wiring in-between. System is compatible only with pure sine wave inverter.