SunFounder Light Follower Module, 3-Channel 3Du5C Phototransistor Sensor For Arduino And Raspberry Pi Robot  (Multicolor)

SunFounder Light Follower Module, 3-Channel 3du5c Phototransistor Sensor for Arduino and Raspberry Pi Robot A three-way light following module uses the MCU STM8S003 as the controller and three 3du5c phototransistors for sensors.|Sensitivity of the transistor adjustable by the blue potentiometer.|Equipped with corresponding indicating lights (8 LEDs) - the strong light, the more brightened LEDs.|Comes with anti-reverse plug and 5-pin anti-reverse cable, for easy and stable wiring.|Working voltage: 5V; PCB size: 124 x 30 mm. Technical Details Introduction Phototransistor, or photo triode, is a photoelectric conversion component that senses the light intensity. The stronger light, the larger currents, and better conductivity of the triode. Based on this principle, we use it for light following. It works by converting the conductivity to voltage output, which means the stronger light shone on it, the smaller voltage output. Then convert the voltage into digital values by the A/D converter on the MCU. And we can tell the light intensity then by this value. The module can be used to sense the ambient luminance. The blue potentiometer is to adjust the sensitivity - you can change it to adapt to specific circumstances. There are two mounting holes of 3mm diameter on the module for easy installation on your robot. All in all, this Light Follower Module is a perfect choice for you to achieve a light following project! More details can be found in http://wiki.sunfounder.cc/index.php?title=Light_Follower_Module Package Included: 1 x Light Follower Module 1 x 5-pin Anti-reverse Cable