SunRobotics OPENPILOT CC3D FLIGHT CONTROLLER  (Yellow)

The CC3D board is all-in-one hardware that runs the stabilization OpenPilot firmware. It can be configured to monitor each cell of fly-wing flies on an octocopter and be monitored via the software OpenPilot Ground Control Station (GCS). CopterControl from the OpenPilot project represents a new generation of multi-purpose aircraft stabilization platforms. The CC3D has been designed from the ground up to the following features: - A multi-rotor controller with auto-level, including TriCopters, QuadCopters and HexaCopters - A flybarless helicopter controller with AutoLevel - A Fixed Wing UAV controller The CopterControl hardware has the following properties: Powerful STM32 32-bit microcontroller running at 90MIPs with 128 KB Flash and 20KB RAM 3 axis high-performance MEMS gyros and 3 axes high-performance MEMS accelerometersTiny 36mmx36mm 4 layer PCB for superior electrical noise reduction and flight performance. Software support for Windows, Mac, and Linux Direct high-speed USB support no drivers required, a real plug & play device. Spectrum satellite receiver support Innovative FlexiPort technology for maximum connection flexibility 4 MBits board EEPROM for configuration memory Powerful STM32 32-bit microcontroller running at 90MIPs with 128 KB Flash and 20KB RAM 3 axis high-performance MEMS gyros and 3 axes high-performance MEMS accelerometers