eZell Edge To Edge Tempered Glass for RENO10 PRO+  (Pack of 1)

How to install it: Step 1 : Clean the screen with the wet wipe and cloth and removing any case from your OPPO RENO10 PRO+ 5G Step 2 : Stick the key hole with a label, and then use a knife or scissor open the liquid adhesive box, drop it on the screen(It is recommended that the glue be poured completely. The glue that drops on the screen can’t have air bubbles, if there is air bubble, use the needle to pierce the air bubble to let go air. ) Step 3 : Place the screen protector to a suitable position on your device SLOWLY. PLEASE DO NOT LIFT AND PRESS THE GLASS TO LET THE ADHESIVE SPREAD,JUST LET IT AUTOMATIC DISPERSION.(Very important) Step 4 : Wait for about half 30 Secs to let the adhesive spread and level. Step 5 : If the adhesive overflow, wipe off with a clean cloth. After checking the retention criteria for the mobile phone’s tempered film, the lamp was turned back and forth several times around the edge of the phone, and after 3 seconds of initial curing (not in the middle), the edge glue was wiped again until the glue overflowed. (Prevent white edges or long bubbles on edges) Step 6 : Wait for the exhaust to complete, after the glue overflows cleanly, after the positioning standard of the tempered film is satisfied, turn on the light. Otherwise scrapped material. Step 7 : Irradiate the mobile phone under UV lamp and need to illuminate twice for about 3 minutes to reach the fully-cured position. * Use Only Basic TypeC / Micro USB TypeB Chargers Fast / Turbo charger might not work properly Step 8 : Clear the screen, and turn off the UV lamp for reuse. Package include: 9)Curved 3D Edge Glass for OPPO RENO10 PRO+ 5G 10)UV Glue 11)UV Light * Free 12)2N1 Wipes Wet&Dry Handling and Packing: Packing done with good amount of care so that you get the item in good condition. it is your responsibility to ensure that the packet received is in non-tampered condition. If the pack is open please refuse to receive the order and return it with same logistics per