MJAuto Carburetor Assembly Compatible For Yamaha Bike RXZ135/RXK/RX135 Vehicle Starter Motor

The motorcycle carburetor assembly is a vital component of the fuel system in a motorcycle engine. It is responsible for mixing the fuel and air in the correct proportion and delivering it to the engine for combustion. Here are the main parts of a typical motorcycle carburetor assembly: Throttle body: This is the part of the carburetor that controls the amount of air that enters the engine. It is connected to the throttle cable, which is controlled by the rider's hand on the handlebar. Float bowl: This is the part of the carburetor that holds the fuel. It is located at the bottom of the carburetor and has a float inside that regulates the fuel level. Jets: Jets are small orifices that regulate the amount of fuel that is mixed with the air. There are usually two jets in a motorcycle carburetor - the pilot jet, which controls fuel flow at low engine speeds, and the main jet, which controls fuel flow at high engine speeds. Needle valve: The needle valve controls the flow of fuel into the engine by varying the size of the fuel orifice. Choke: The choke is a mechanism that restricts the flow of air into the engine, making it easier to start the engine when it's cold. Air filter: The air filter is a component that prevents dirt and debris from entering the engine. To assemble a motorcycle carburetor, you will need to follow the instructions provided by the manufacturer and ensure that each part is installed correctly. It is important to use the correct tools and be gentle when handling the delicate parts of the carburetor. Once the carburetor is assembled, it will need to be adjusted to ensure that the fuel mixture is correct for your specific motorcycle. This is typically done using a combination of adjustments to the jets, needle valve, and throttle cable.