SG Flash L298N Dual H Bridge DC Stepper Motor Driver Controller Board Module for Arduino Motor Control Electronic Hobby Kit

Product description: L298N driver module, with ST L298N chip can directly drive two 3-30V DC motors and provide 5V output interface, you can repair the power circuit to 5V, support 3.3VMCU control, you can easily control the speed and direction DC motor, you can also drive a 2-phase stepper motor, an indispensable smart car.DESCRIPTION The L298 is an integrated monolithic circuit in a 15- lead Multiwatt and PowerSO20 packages. It is a high voltage, high current dual full-bridge driver designed to accept standard TTL logic levels and drive inductive loads such as relays, solenoids, DC and stepping motors. Two enable inputs are provided to enable or disable the device independently of the input signals. The emitters of the lower transistors of each bridge are connected together and the corresponding external terminal can be used for the connection of an external sensing resistor. An additional supply input is provided so that the logic works at a lower voltage.OPERATING SUPPLY VOLTAGE UP TO 46V LOW SATURATION VOLTAGE TOTAL DC CURRENT UP TO 4A LOGICAL \"0\" INPUT VOLTAGE UP TO 1.5 V (HIGH NOISE IMMUNITY) OVERTEMPERATURE PROTECTION