Skins HUB Droping Art 1 Skin For Air Pods 3 Type-1, Droping Art 1, Air Pods 3 Type-1 Mobile Skin  (Droping Art 1 Skin With Super matte finish)

Skins Hubs Skin Kit for Your Mobile Proactive is printed with super-high resolution graphics. Skins Factory Skins easy to install and removal. Mobile will leave behind no decals residue. Skins decals for puds will prevent dust proof, waterproof, oil proof and fingerprints. Decals for Remote custom will not Scratch Fade (UV Resistant) or Peel. Install: 1) Clean the unit's surface as thoroughly as possible. Use rubbing Wipes on a lint-free cloth to remove any grease or other contaminates. Most issues of non-sticking are due to some type of oil or grease. 2) Peel one piece of Decals from the paper liner. NOT to let the adhesive side touch anything. 3) Determine the placement, apply the Skin to the surface using your fingers or the side of your thumb, starting from one corner and working your way across the surface. 4) If a piece is not going on straight, you can gently lift it back up. Do not stretch it from its original size. 5) If installed slowly and carefully, there should be NO air bubbles left under the sticker. Any air that may become trapped during installation will go away in time. 6) During the cold weather or for a better result, apply hot air to the decal surface by using a hair dryer or hot air gun to activate chemical agent while putting the sticker. Especially heat up the edge surface. Allow at least 3 hours for cool down before touching the decal sticker skin.